|
| | |
|
|
1. Parts List
|
The following hardware is included in your Superlift 2 package |
|
For Attaching the Spring to the Spring Bracket
|
Two (2) 3/8" x 5/8" Clevis Pins
|
|
|
Two (2) Flat Washers
|
|
|
Two (2) Cap Nuts
|
|
|
For installing pivot brackets
Four (4) 3/8" x 1 1/4" Lag Bolts
|
For attaching Springs to Lag Bolts
Two (2) 3/8" x 4" Lag Eye Bolts
 |
|
For attaching Handlebar to the Saddle
Two (2) Nylock Hex Nuts
|
| |
Two (2) 5/15" x 2 1/4" Phil Pan Screws
 |
|
|
Items not pictured: Two (2) Springs, Two (2) Spring Bracket Sets, Two (2) Pivot Arms, Two (2) Handle Bars, One (1) Torsion Bar |
|
2. Tool List
|
The following tools are needed to install your Superlift 2
|
Power drill with 5/16" drill bit
Socket wrench with 1/2" and 9/16" sockets
Large head Phillips screw driver
Awl
Tape Measure
Level
|
|
FOR THE SAKE OF YOUR EYES... ALWAYS WEAR PROTECTIVE EYE WEAR
|
WARNING:
|
ALL HARDWARE MUST BE PROPERLY TIGHTENED BEFORE OPERATION OF LIFT, FAILURE TO DO SO MAY RESULT IN INJURY OR DAMAGE TO LIFT/SPA
|
|
|
CAUTIONS |
- Be sure to read all installation steps before beginning.
- Many steps only show the installation of your cover lifter on one side of your hot tub. To complete your installation, repeat the same steps on the opposite side of your hot tub.
|
|
Assembly
|
- Measure the width of your hot tub from the outside edges of the shell. (Do not measure the width of the cabinet.) Use the chart below to determine the correct spot at which to mount the Pivot Bracket and the Eye Bolt to the hot tub's cabinet
- On the bottom of the graph, locate the size of your Hot Tub (chart is listed in inches).
- Follow your size up the graph until it intersects with the diagonal line.
- At this point on the diagonal line, move left to the side of the graph to determine the number of inches (A) from the hot tub's center point (B) to mark the center point of the Pivot Bracket for mounting. (see fig 1 below)
- Holding the Pivot Bracket in place, mark each of the holes for pre-drilling.
- To locate the point to mount the Eye Bolt to the base of the hot tub, start at the edge of the mounted pivot bracket nearest the center line of the hot tub (C), and drop straight down (perpendicular to the base) to the 2" x 4" base support of the hot tub's cabinet. Mark and mount the Eye Bolt at this point. (D)
|
Important Points of Installation
A. Center point of Pivot Bracket: this is a point measured back from the tub's center point.
B. Centerline of hot tub: the diameter of the tub divided in half.
C. Right edge of pivot bracket.
D. Point to mount eye bolt.
|
|
|
|
| |
| | |
|
|
|